LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2017 >> Rogue S, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Anti-Theft Systems >> Door & Lock (With Intelligent Key System) (Circuit Diagnosis, Symptom Diagnosis & Removal And Installation) (Except Hybrid) >> Circuit Diagnosis >> Outside Key Antenna (Rear Bumper) >> Diagnosis Procedure

Diagnosis Procedure

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

  1. CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 1

    1. Turn ignition switch OFF.
    2. Check signal between BCM harness connector and ground using oscilloscope.
      (+) (-) Condition Signal
      (Reference value)
      BCM
      Connector Terminal
      B16 61, 64 Ground When the driver door request switch is operated with ignition switch OFF. When Intelligent Key is in the antenna detection area. (The distance between Intelligent Key and antenna: 80 cm or less.)
      GNSJMKIA5955GB-955Courtesy of NISSAN NORTH AMERICA, INC.
      When Intelligent Key is not in the antenna detection area. (The distance between Intelligent Key and antenna: Approx. 2 m.)
      GNSJMKIA5954GB-954Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES 

    Replace BCM. Refer to REMOVAL AND INSTALLATION .

    NO 

    GO TO STEP 2  .

  2. CHECK OUTSIDE KEY ANTENNA CIRCUIT

    1. Disconnect BCM connector and outside key antenna (rear bumper) connector.
    2. Check continuity between BCM harness connector and outside key antenna (rear bumper) harness connector.
      BCM Outside key antenna (rear bumper) Continuity
      Connector Terminal Connector Terminal
      B16 64 B76 1 Yes
      61 2
    3. Check continuity between BCM harness connector and ground.
      BCM Ground  
      Continuity
      Connector Terminal
      B16 64 No
      61

    Is the inspection result normal?

    YES 

    GO TO STEP 3  .

    NO 

    Repair or replace harness.

  3. CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 2

    1. Replace outside key antenna (rear bumper). (New antenna or other antenna)
    2. Connect BCM and outside key antenna (rear bumper) connector.
    3. Check signal between BCM harness connector and ground using oscilloscope.
      (+) (-) Condition Signal
      (Reference value)
      BCM
      Connector Terminal
      B16 61, 64 Ground When the driver door request switch is operated with ignition switch OFF. When Intelligent Key is in the antenna detection area. (The distance between Intelligent Key and antenna: 80 cm or less.)
      GNSJMKIA5955GB-955Courtesy of NISSAN NORTH AMERICA, INC.
      When Intelligent Key is not in the antenna detection area. (The distance between Intelligent Key and antenna: Approx. 2 m.)
      GNSJMKIA5954GB-954Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES 

    Replace outside key antenna (rear bumper). Refer to REMOVAL AND INSTALLATION .

    NO 

    Replace BCM. Refer to REMOVAL AND INSTALLATION .