LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2017 >> Rogue S, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Anti-Theft Systems >> Door & Lock (With Intelligent Key System) (Circuit Diagnosis, Symptom Diagnosis & Removal And Installation) (Except Hybrid) >> Circuit Diagnosis >> Outside Key Antenna (Driver Side) >> Diagnosis Procedure

Diagnosis Procedure

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

  1. CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 1

    1. Turn ignition switch OFF.
    2. Check signal between BCM harness connector and ground using oscilloscope.
      (+) (-) Condition Signal
      (Reference value)
      BCM
      Connector Terminal
      M19 100, 120 Ground When the driver door request switch is operated with ignition switch OFF. When Intelligent Key is in the antenna detection area. (The distance between Intelligent Key and antenna: 80 cm or less.)
      GNSJMKIA5955GB-955Courtesy of NISSAN NORTH AMERICA, INC.
      When Intelligent Key is not in the antenna detection area. (The distance between Intelligent Key and antenna: Approx. 2 m.)
      GNSJMKIA5954GB-954Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES 

    Replace BCM. Refer to REMOVAL AND INSTALLATION .

    NO 

    GO TO STEP 2  .

  2. CHECK OUTSIDE KEY ANTENNA CIRCUIT

    1. Disconnect BCM connector and outside key antenna (LH) connector.
    2. Check continuity between BCM harness connector and outside key antenna (LH) harness connector.
      BCM Outside key antenna (LH) Continuity
      Connector Terminal Connector Terminal
      M19 100 D11 1 Yes
      120 2
    3. Check continuity between BCM harness connector and ground.
      BCM Ground Continuity
      Connector Terminal
      M19 100 No
      120

    Is the inspection result normal?

    YES 

    GO TO STEP 3  .

    NO 

    Repair or replace harness.

  3. CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 2

    1. Replace outside key antenna (LH). (New antenna or other antenna)
    2. Connect BCM connector and outside key antenna (LH) connector.
    3. Check signal between BCM harness connector and ground using oscilloscope.
      (+) (-) Condition Signal
      (Reference value)
      BCM
      Connector Terminal
      M19 100, 120 Ground When the driver door request switch is operated with ignition switch OFF. When Intelligent Key is in the antenna detection area. (The distance between Intelligent Key and antenna: 80 cm or less.)
      GNSJMKIA5955GB-955Courtesy of NISSAN NORTH AMERICA, INC.
      When Intelligent Key is not in the antenna detection area. (The distance between Intelligent Key and antenna: Approx. 2 m.)
      GNSJMKIA5954GB-954Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES 

    Replace outside key antenna (LH). Refer to REMOVAL AND INSTALLATION .

    NO 

    Replace BCM. Refer to REMOVAL AND INSTALLATION .