LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2016 >> Rogue S, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Exterior Lighting System (Halogen Headlamp) (DTC/Circuit Diagnosis) >> Circuit Diagnosis >> Hazard Switch >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK HAZARD SWITCH SIGNAL INPUT

    1. Turn ignition switch OFF.
    2. Disconnect hazard switch connector.
    3. Check voltage between hazard switch connector and ground.
    (+) (-) Voltage (Approx.)
    Hazard switch
    Connector Terminal
    M26 2 Ground Battery voltage

    Is the inspection result normal?

    YES 

    GO TO STEP 4  .

    NO 

    GO TO STEP 2  .

  2. CHECK HAZARD SWITCH SIGNAL OPEN CIRCUIT

    1. Disconnect BCM connector.
    2. Check continuity between hazard switch harness connector and BCM harness connector.
    Hazard switch BCM Continuity
    Connector Terminal Connector Terminal
    M26 2 M18 11 Yes

    Is the inspection result normal?

    YES 

    GO TO STEP 3  .

    NO 

    Repair or replace harness.

  3. CHECK HAZARD SWITCH SIGNAL SHORT CIRCUIT

    Check continuity between hazard switch harness connector and ground.

    Hazard switch Ground Continuity
    Connector Terminal
    M26 2 No

    Is the inspection result normal?

    YES 

    Replace BCM. Refer to REMOVAL AND INSTALLATION (with Intelligent Key system) or REMOVAL AND INSTALLATION (without Intelligent Key system).

    NO 

    Repair or replace harness.

  4. CHECK HAZARD SWITCH GROUND OPEN CIRCUIT

    Check continuity between hazard switch harness connector and ground.

    Hazard switch Ground Continuity
    Connector Terminal
    M26 3 Yes

    Is the inspection result normal?

    YES 

    Replace hazard switch. Refer to REMOVAL AND INSTALLATION .

    NO 

    Repair or replace harness.

scientia non olet · About LEMON Manuals