Diagnostic Test
- CHECK STOP LAMP SWITCH
- Ignition switch ON.
- Check voltage between stop lamp switch connector E13 terminal 4 and ground.
Stop lamp switch Ground Brake pedal Voltage Connector Terminal E13 4 Ground Applied Battery voltage Released 0V
Is the inspection result normal?
YES
GO TO STEP 2 .
NO
GO TO STEP 4 .
- CHECK CVT SHIFT SELECTOR
Check voltage between CVT shift selector connector M38 terminal 6 and ground.
CVT shift selector Ground Brake pedal Shift selector Voltage Connector Terminal M38 6 Ground Applied Park Battery voltage Others 0V Is the inspection result normal?
YES
GO TO STEP 3 .
NO
GO TO STEP 5 .
- CHECK GROUND CIRCUIT
- Ignition switch OFF.
- Disconnect CVT shift selector connector.
- Check continuity between CVT shift selector connector M38 terminal 6 and ground.
CVT shift selector Ground Continuity Connector Terminal M38 6 Ground Yes Is the inspection result normal?
YES
Replace CVT shift selector. Refer to REMOVAL AND INSTALLATION .
NO
Repair or replace ground circuit.
- CHECK STOP LAMP SWITCH POWER CIRCUIT
Check voltage between stop lamp switch connector E13 terminal 3 and ground.
Stop lamp switch Ground Voltage Connector Terminal E13 3 Ground Battery voltage Is the inspection result normal?
YES
Replace stop lamp switch.
NO
Repair or replace power circuit.
- CHECK CVT SHIFT SELECTOR POWER CIRCUIT
Check voltage between CVT shift selector connector M38 terminal 5 and ground.
CVT shift selector Ground Brake pedal Voltage Connector Terminal M38 5 Ground Applied Battery voltage Is the inspection result normal?
YES
Replace CVT shift selector. Refer to REMOVAL AND INSTALLATION .
NO
Repair or replace power circuit.