LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2015 >> Versa Note SL >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission (Diagnostic Trouble Codes (DTCS) P0713-P285A, Symptom Tests And R & I) (CVT: Re0F11A) >> DTC/Circuit Diagnosis >> Overdrive Control Switch >> Diagnosis Procedure >> Diagnostic Test

Diagnostic Test

  1. CHECK OVERDRIVE CONTROL SWITCH CIRCUIT

    1. Turn ignition switch OFF.
    2. Disconnect CVT shift selector connector.
    3. Turn ignition switch ON.
    4. Check voltage between CVT shift selector harness connector terminals.
      CVT shift selector Voltage
      (Approx.)
      Connector + -
      Terminal
      M38 1 2 5 V

    Is the inspection result normal?

    YES 

    GO TO STEP 2  .

    NO 

    GO TO STEP 4  .

  2. CHECK OVERDRIVE CONTROL SWITCH

    Check overdrive control switch. Refer to COMPONENT INSPECTION (OVERDRIVE CONTROL SWITCH) .

    Is the inspection result normal?

    YES 

    GO TO STEP 3  .

    NO 

    Repair or replace malfunctioning parts.

  3. CHECK GROUND CIRCUIT

    Check continuity between CVT shift selector harness connector terminal and ground.

    CVT shift selector - Continuity
    Connector Terminal
    M38 2 Ground Existed

    Is the inspection result normal?

    YES 

    GO TO STEP 4  .

    NO 

    Repair or replace malfunctioning parts.

  4. CHECK CIRCUIT BETWEEN COMBINATION METER AND CVT SHIFT SELECTOR (PART 1)

    1. Turn ignition switch OFF.
    2. Disconnect combination meter connector.
    3. Check continuity between combination meter harness connector terminal and CVT shift selector harness connector terminal.
      Combination meter CVT shift selector Continuity
      Connector Terminal Connector Terminal
      M24 8 M38 1 Existed

    Is the inspection result normal?

    YES 

    GO TO STEP 5  .

    NO 

    Repair or replace malfunctioning parts.

  5. CHECK CIRCUIT BETWEEN COMBINATION METER AND CVT SHIFT SELECTOR (PART 2)

    Check continuity between combination meter harness connector terminal and ground.

    Combination meter - Continuity
    Connector Terminal
    M24 8 Ground Not existed

    Is the inspection result normal?

    YES 

    GO TO STEP 6  .

    NO 

    Repair or replace malfunctioning parts.

  6. CHECK COMBINATION METER INPUT SIGNAL

    1. Connect all of disconnected connectors.
    2. Turn ignition switch ON.
    3. Select "Data Monitor" in "METER/M&A".
    4. Select "O/D OFF SW".
    5. Check that "O/D OFF SW" turns ON/OFF when overdrive control switch is operated. Refer to REFERENCE VALUE .

    Is the inspection result normal?

    YES 

    Check intermittent incident. Refer to INTERMITTENT INCIDENT .

    NO 

    Replace combination meter. Refer to REMOVAL AND INSTALLATION .

scientia non olet · About LEMON Manuals