DTC Confirmation Procedure
CAUTION:
Be careful of the driving speed.
- PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
GO TO STEP 2 .
- CHECK DTC DETECTION
With CONSULT
- Start the engine.
- Select "Data Monitor" in "TRANSMISSION".
- Select "G SPEED".
- Drive the vehicle.
- Maintain the following conditions for 10 seconds or more.
Selector lever : "D" position G SPEED : 0.05 G or more - Stop the vehicle.CAUTION:
Never stop the engine.
- Repeat steps 4 through 6.
- Check the DTC.
Is "P1588" detected?
YES
Go to DIAGNOSIS PROCEDURE .
NO
INSPECTION END