| P0846 |
Transmission Fluid Pressure Sensor/Switch B Circuit Range/Performance |
The detection conditions continuously for 5 seconds or more under the following diagnosis conditions:
- Diagnosis conditions
- Selector lever: "D" position
- The primary pulley speed experienced 306 RPM or more and the secondary pulley speed experienced 230 RPM or more at least once.
- Wheel spin is not being detected.
- The rate of change in pulley ratio: Between - 0.09 and +0.09 inclusive
- Solenoid valve output current: 750 mA or more
- GND short diagnosis of the solenoid valve circuit is not satisfied.
- TCM power supply voltage: More than 11 V
- Detection conditions
- After the value of "Actual secondary pressure - Target secondary pressure" exceeds 0.675 MPa:
- The rate of change in vehicle speed [km/h (MPH)]: Between - 49 (- 30) and +49 (+30) inclusive
- The rate of change in accelerator pedal angle: Between - 1.3/8 and +1.3/8 inclusive
|
- Secondary pressure sensor
- Control valve assembly
|