DTC Confirmation Procedure

CAUTION:

Be careful of the driving speed.

PREPARATION BEFORE OPERATION 1

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

GO TO STEP 2 .

PREPARATION BEFORE OPERATION 2

With CONSULT
1. Start the engine.
2. Select "Data Monitor" in "TRANSMISSION".
3. Select "FLUID TEMP".
4. Confirm that the CVT fluid temperature is in the range below.
  
  FLUID TEMP : 20°C (68°F) or more
With GST
1. Start the engine.
2. Set the CVT fluid to 20°C (68°F) or more.
  NOTE:
  When the ambient temperature is 20°C (68°F), the CVT fluid usually increases to 50 to 80°C (122 to 176°F) with driving in an urban area for approximately 10 minutes.
Is the CVT fluid 20°C (68°F) or more?

YES

GO TO STEP 3 .

NO
1. Warm the transaxle.
2. GO TO STEP 3 .

CHECK DTC DETECTION

Drive the vehicle.

Maintain the following conditions for 40 seconds or more.

Selector lever	: "D" position
Accelerator pedal position	: 1.0/8 or more
Vehicle speed	: 40 km/h (25 MPH) or more

Stop the vehicle.
Check the first trip DTC.

Is "P0744" detected?

YES

Go to DIAGNOSIS PROCEDURE .

NO

INSPECTION END