DTC Confirmation Procedure

CAUTION:

Be careful of the driving speed.

PREPARATION BEFORE OPERATION (PART 1)

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

GO TO STEP 2 .

PREPARATION BEFORE OPERATION (PART 2)

With CONSULT
1. Start the engine.
2. Select "Data Monitor" in "TRANSMISSION".
3. Select "FLUID TEMP".
4. Confirm that the CVT fluid temperature is in the following range.
  
  FLUID TEMP : 10°C (50°F) or more
With GST
1. Start the engine.
2. Set the CVT fluid to 10°C (50°F) or more.
  NOTE:
  When the ambient temperature is 20°C (68°F), the CVT fluid usually increases to 50 to 80°C (122 to 176°F) with driving in an urban area for approximately 10 minutes.
Is the CVT fluid 10°C (50°F) or more?

YES

GO TO STEP 3 .

NO
1. Warm the transaxle.
2. GO TO STEP 3 .

CHECK DTC DETECTION

Drive the vehicle.

Maintain the following conditions for 10 seconds or more.

Selector lever	: "D" position
Vehicle speed	: 40 km/h (25 MPH) or more

Stop the vehicle.
Check the first trip DTC.

Is "P0740" detected?

YES

Go to DIAGNOSIS PROCEDURE .

NO

INSPECTION END