| P0720 |
Output Speed Sensor Circuit |
The output speed sensor value is less than 150 RPM continuously for 10 seconds or more under the following diagnosis conditions:
- Diagnosis conditions
- Selector lever: "D", "L" or "R" position
- Auxiliary gearbox shifting is not in progress.
- When the "D" position switch, "L" position switch or "R" position switch is ON, the output speed has not experienced 250 RPM or more.
- After shifting the selector lever, the input speed has experienced less than 300 RPM.
- Secondary pulley speed: 1, 500 RPM or more
- TCM power supply voltage: More than 11 V
|
|