DTC Confirmation Procedure
CAUTION:
Be careful of the driving speed.
- PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
GO TO STEP 2.
- CHECK DTC DETECTION
- Start the engine.
- Drive the vehicle.
- Maintain the following conditions for 10 seconds or more.
Selector lever : "D" position Vehicle speed : 55 km/h (34 MPH) or more - Stop the vehicle.
- Check the first trip DTC.
Is "P0720" detected?
YES
Go to DIAGNOSIS PROCEDURE .
NO
INSPECTION END