DTC Confirmation Procedure
CAUTION:
Be careful of the driving speed.
- PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
GO TO STEP 2 .
- CHECK DTC DETECTION
- Start the engine.
- Drive the vehicle.
- Maintain the following conditions for 10 seconds or more.
Selector lever : "L" POSITION Vehicle speed : 40 km/h (25 MPH) or more - Stop the vehicle.
- Check the first trip DTC.
Is "P0715" detected?
YES
Go to DIAGNOSIS PROCEDURE .
NO
INSPECTION END