Calibration Procedure

The compass display is equipped with an automatic correction function. If the compass display reads "CAL" or the direction is not shown correctly, perform the correction procedure below.

1. Press and hold the (N) switch for about 10 seconds. The display will read "CAL".
2. Drive the vehicle slowly in a circle, in an open, safe place. The initial calibration is completed in about 3 turns.
   NOTE: In places where the terrestrial magnetism is extremely disturbed, the initial correction may start automatically.
   Fig 1: Identifying Universal Transceiver

   Courtesy of NISSAN NORTH AMERICA, INC.