Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

1. CHECK WASHER LEVEL SWITCH SIGNAL CIRCUIT 
   1. Turn ignition switch OFF.
   2. Disconnect combination meter connector and washer fluid level switch connector.
   3. Check continuity between combination meter harness connector and washer fluid level switch harness connector.

      Terminals				Continuity
      Combination meter		Washer fluid level switch
      Connector	Terminal	Connector	Terminal
      M24	17	E65	1	Yes

   4. Check continuity between combination meter harness connector and ground.

      Terminals			Continuity
      Combination meter		Ground
      Connector	Terminal
      M24	17		No

      Is the inspection result normal? 

      YES: GO TO 2.

      NO: Repair or replace harness or connector.

2. CHECK WASHER FLUID LEVEL SWITCH GROUND CIRCUIT 

   Check continuity between washer fluid level switch connector and ground.

   Terminals			Continuity
   Washer level switch		Ground
   Connector	Terminal
   E52	2		Yes

   Is the inspection result normal? 

   YES: Inspection End.

   NO: Repair or replace harness or connector.