LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2013 >> Rogue S, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter, Warning Lamp & Indicator >> Ecu Diagnosis Information >> Combination Meter >> Reference Value >> Physical Values

Physical Values

Terminal No. (Wire color) Description Condition Value (Approx.)
+ - Signal name Input/Output
1 (LG) Ground Battery power supply Input Ignition switch OFF - Battery voltage
2 (BG) Ground Ignition signal Input Ignition switch ON - Battery voltage
3 (B) Ground Ground - Ignition switch ON - 0 V
4 (L) Ground SPORT mode switch signal Input Ignition switch ON SPORT mode switch pressed 0 V
SPORT mode switch not pressed 12 V
5 (BR) Ground A/C auto amp. connection recognition signal Input Ignition switch ON When auto amp. is connected 5 V
Other than the above 0 V
7 (GR) Ground Overdrive control switch signal Input Ignition switch ON Overdrive control switch pressed 0 V
Overdrive control switch not pressed 12 V
9 (L) Ground Paddle shifter shift up signal Input Ignition switch ON Paddle shifter shift up operation 0 V
Other than the above 12 V
10 (G) Ground Paddle shifter shift down signal Input Ignition switch ON Paddle shifter shift down operation 0 V
Other than the above 12 V
13 (Y) Ground Illumination control signal Output Ignition switch ON
  • Lighting switch 1ST position
  • When meter illumination is maximum
G05917979
  • Lighting switch 1ST position
  • When meter illumination is step 11
G05917980
  • Lighting switch 1ST position
  • When meter illumination is minimum
 12 V
15 (LG) Ground Air bag signal Input Ignition switch ON Air bag warning lamp ON 4 V
Air bag warning lamp OFF 0 V
16 (W) Ground Engine coolant temperature signal Output Ignition switch ON Engine idling [Approximately 20°C (68°F)]
G05915633
Engine idling [Approximately 80°C (176°F)]
G05915634
19 (BR) Ground Ambient sensor signal Input Ignition switch ON -
G05223707
20 (SB) Ground Ambient sensor ground - Ignition switch ON - 0 V
21 (L) - CAN-H - - - -
22 (P) - CAN-L - - - -
24 (B) Ground Fuel level sensor signal ground - Ignition switch ON - 0 V
25 (SB) Ground Alternator signal Input Ignition switch ON Charge warning lamp ON 0 V
Charge warning lamp OFF 12 V
26 (V) Ground Parking brake switch signal Input Ignition switch ON Parking brake ON 0 V
Parking brake OFF 5 V
27 (BR) Ground Brake fluid level switch signal Input Ignition switch ON Brake fluid level is normal 5 V
Brake fluid level is less than low level 0 V
28 (B) Ground Security signal Input Ignition switch OFF Security warning lamp ON 0 V
Security warning lamp OFF 12 V
29 (W) Ground Washer level switch signal Input Ignition switch OFF Washer level switch ON 0 V
Washer level switch OFF 12 V
30 (Y) Ground Vehicle speed signal (2-pulse) Output Ignition switch ON Speedometer operated [When vehicle speed is approx. 40 km/h (25 MPH)]
NOTE: The maximum voltage varies depending on the specification (destination unit).
G05223700
31 (L) Ground Vehicle speed signal (8-pulse) Output Ignition switch ON Vehicle speed is approximately 40 km/h (25 MPH)
NOTE: The maximum voltage varies depending on the specification (destination unit).
G05223684
34 (G) Ground Fuel level sensor signal Input Ignition switch ON -
G07135999
35 (BG) Ground Seat belt buckle switch signal (driver side) Input Ignition switch ON When driver seat belt is fastened 12 V
When driver seat belt is not fastened 0 V
36 (G) Ground Seat belt buckle switch signal (passenger side) Input Ignition switch ON
  • When getting in the passenger seat
  • When passenger seat belt is fastened
 12 V
  • When getting in the passenger seat
  • When passenger seat belt is not fastened
 0 V
37 (P) Ground Non-manual mode signal Input Ignition switch ON Manual mode 12 V
Other than the above 0 V
38 (BG) Ground Manual mode shift down signal Input Ignition switch ON Selector lever (-) position 0 V
Other than the above 12 V
39 (V) Ground Manual mode shift up signal Input Ignition switch ON Selector lever (+) position 0 V
Other than the above 12 V
40 (LG) Ground Manual mode signal Input Ignition switch ON Manual mode 0 V
Other than the above 12 V
scientia non olet · About LEMON Manuals