LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2013 >> Rogue S, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter, Warning Lamp & Indicator >> DTC/Circuit Diagnosis >> A/C Auto Amp. Connection Recognition Signal Circuit >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK A/C AUTO AMP. CONNECTION RECOGNITION SIGNAL 
    1. Turn ignition switch ON.
    2. Check voltage between combination meter harness connector and ground.
      Terminals Voltage (Pyrex.)
      (+) (-)
      Combination meter Ground
      Connector Terminal
      M34 5 5 V

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: GO TO 2.

  2. CHECK A/C AUTO AMP. CONNECTION RECOGNITION SIGNAL CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect combination meter connector and auto amp. connector.
    3. Check continuity between combination meter harness connector and auto amp. harness connector.
      Combination meter Auto amp. Continuity
      Connector Terminal Connector terminal
      M34 5 M55 28 Existed
    4. Check continuity between combination meter harness connector and ground.
      Combination meter Ground Continuity
      Connector Terminal
      M34 5 Not existed

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Repair harness or connector.

scientia non olet · About LEMON Manuals