LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2013 >> Rogue S, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Body Control System >> DTC/Circuit Diagnosis >> Combination Switch Output Circuit >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK OUTPUT 1 - 5 CIRCUIT FOR OPEN 
    1. Turn the ignition switch OFF.
    2. Disconnect BCM and combination switch connectors.
    3. Check continuity between BCM harness connector and combination switch harness connector.
      System BCM Combination switch Continuity
      Connector Terminal Connector Terminal
      OUTPUT 1 M65 36 M27 1 Existed
      OUTPUT 2 35 2
      OUTPUT 3 34 3
      OUTPUT 4 33 4
      OUTPUT 5 32 5

      Does continuity exist? 

      YES: GO TO 2.

      NO: Repair the harnesses or connectors.

  2. CHECK OUTPUT 1 - 5 CIRCUIT FOR SHORT 

    Check for continuity between BCM harness connector and the ground.

    System BCM Ground Continuity
    Connector Terminal
    OUTPUT 1 M65 36 Not existed
    OUTPUT 2 35
    OUTPUT 3 34
    OUTPUT 4 33
    OUTPUT 5 32

    Does continuity exist? 

    YES: Repair the harnesses or connectors.

    NO: GO TO 3.

  3. CHECK BCM OUTPUT VOLTAGE 
    1. Connect BCM connector.
    2. Check voltage between BCM harness connector and the ground.
      System Terminals Voltage (Approx.)
      (+) (-)
      BCM Ground
      Connector Terminal
      OUTPUT 1 M65 36 Refer to "REFERENCE VALUE ".
      OUTPUT 2 35
      OUTPUT 3 34
      OUTPUT 4 33
      OUTPUT 5 32

      Is the measurement value normal? 

      YES: GO TO 4.

      NO: Replace BCM. Refer to "EXPLODED VIEW ".

  4. CHECK COMBINATION SWITCH 

    Check combination switch. Refer to "DESCRIPTION ".

    Is the check result normal? 

    YES: Replace BCM. Refer to "EXPLODED VIEW ".

    NO: Replace the combination switch (applicable parts).

scientia non olet · About LEMON Manuals