Front Wiper Intermittent Operation Switch Position Cannot Be Adjusted
- CHECK CIRCUIT BETWEEN COMBINATION SWITCH AND BCM
With CONSULT
- Select "BCM" on CONSULT, and select "WIPER" on "SELECT TEST ITEM" screen.
- Select "DATA MONITOR". Make sure that "INT VOLUME", changes in order from 1 to 7 according to wiper switch operation.
Without CONSULT
Refer to , "COMBINATION SWITCH INSPECTION ".
OK or NG
OK: Replace BCM. Refer to , "REMOVAL AND INSTALLATION OF BCM ".
NG: Check combination switch (wiper switch). Refer to , "COMBINATION SWITCH INSPECTION ".