Front Wiper Does Not Stop

CHECK CIRCUIT BETWEEN COMBINATION SWITCH AND BCM
With CONSULT
1. Select "BCM" on CONSULT, and select "WIPER" on "SELECT TEST ITEM" screen.
2. Select "DATA MONITOR". Make sure that "FR WIPER INT", "FR WIPER LOW", "FR WIPER HI", and "FR WASHER SW" turn ON-OFF according to front wiper switch operation.
Without CONSULT

Refer to , "COMBINATION SWITCH INSPECTION ".

OK or NG

OK: Replace IPDM E/R. Refer to , "REMOVAL AND INSTALLATION OF IPDM E/R ".

NG: Check combination switch (wiper switch). Refer to , "COMBINATION SWITCH INSPECTION ".