LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Sentra SE-R >> Repair and Diagnosis >> Engine Mechanical >> Engine Mechanical (Qr25DE) >> Service Information >> Camshaft >> Removal and Installation >> Inspection After Removal >> Camshaft Runout

Camshaft Runout

  1. Put the camshaft on a V-block supporting the No. 2 and No. 5 journals.
  2. Set the dial gauge vertically on the No. 3 journal.
  3. Turn camshaft in one direction by hand, and measure the camshaft runout on the dial gauge total indicator reading.

    Standard: Less than 0.04 mm (0.0016 in) 

    Fig 1: Checking Camshaft Runout
    G04885737Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals