Removal Of Liquid Gasket Sealant

After removing the bolts and nuts, separate the mating surface and remove the sealant using Tool.
Tool number: KV10111100 (J-37228)

Fig 1: Tapping Seal Cutter
Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION: Be careful not to damage the mating surfaces.
In areas where the cutter is difficult to use, use a plastic hammer to lightly tap (1) the cutter where the RTV Silicone Sealant is applied. Use a plastic hammer to slide the cutter (2) by tapping on the side.