LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Sentra SE-R >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Engine Mechanical (Qr25DE) >> Service Information >> Oil Seal >> Removal and Installation of Valve Oil Seal >> Installation

Removal and Installation of Valve Oil Seal: Installation

  1. Apply new engine oil to new valve oil seal joint surface and seal lip.
  2. Press in valve oil seal to the position shown below using Tool.

    Oil seal installed height (A): 12.1 mm (0.476 in) 

    Tool number: KV10115600 (J-38958) 

    Fig 1: Installing Valve Oil Seal
    G04924848Courtesy of NISSAN NORTH AMERICA, INC.
  3. Installation of the remaining components in the reverse order of removal.
scientia non olet · About LEMON Manuals