LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Sentra SE-R >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Engine Mechanical (Qr25DE) >> Service Information >> Camshaft >> Removal and Installation >> Inspection After Removal >> Camshaft Sprocket Runout

Camshaft Sprocket Runout

  1. Install the camshaft in the cylinder head.
  2. Install the camshaft sprocket on the camshaft.
  3. Measure camshaft sprocket runout while turning the camshaft by hand.

    Runout: Less than 0.15 mm (0.0059 in) 

    Fig 1: Measuring Camshaft Sprocket Runout
    G04899735Courtesy of NISSAN NORTH AMERICA, INC.
  4. If it exceeds the specification, replace camshaft sprocket.
scientia non olet · About LEMON Manuals