LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Sentra SE-R >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Unit Removal And Installation >> Cluster Lid C >> Removal and Installation >> Removal

Removal and Installation: Removal

  1. Remove the CVT shift selector handle (if equipped). Refer to SHIFT SELECTOR HANDLE REMOVAL AND INSTALLATION .
  2. Move shift selector to neutral position, then rotate M/T shift selector knob in a counterclockwise direction to remove from shift selector (if equipped).
  3. Release the M/T or CVT finisher, disconnect necessary connectors and remove finisher. Refer to COMPONENT PARTS .
  4. Release the clips using a suitable tool, disconnect harness connectors, then remove the controller finisher.
  5. Remove the cluster lid C upper mask (non SE-R models). Refer to COMPONENT PARTS .
  6. Remove the double meter (SE-R models). Refer to REMOVAL AND INSTALLATION .
  7. Remove cluster lid C (1).
    1. Remove cluster lid C screws (A).
    2. Pull out cluster lid C (1) to disconnect harness connector and remove cluster lid C (1).
      Fig 1: Identifying Cluster Lid C And Screws
      G04928061Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals