Front Parking Lamps Do Not Illuminate (License Plate and Tail Lamps Operate Normally)

Inspect parking lamp 10A fuse (No. 37, located in IPDM E/R)

OK or NG 

OK: GO TO 2.

NG: Repair harness.

With CONSULT

1. Turn ignition switch OFF.
2. Disconnect front combination lamp connectors.
3. Turn ignition switch ON.
4. Select "IPDM E/R" on CONSULT, and select "ACTIVE TEST".
5. Select "TAIL LAMP" on "SELECT TEST ITEM" screen.
6. Touch "ON" on "ACTIVE TEST" screen.
7. When tail lamp relay is operating, check voltage between front combination lamp and ground.

Without CONSULT

1. Turn ignition switch OFF.
2. Disconnect front combination lamp connectors.
3. Turn ignition switch ON.
4. Start auto active test. Refer to , "AUTO ACTIVE TEST ".
5. When tail lamp relay is operating, check voltage between front combination lamp and ground.

   Terminal				Voltage
   (+)			(-)
   Front combination lamp connector		Terminal
   RH	E20	1	Ground	Battery voltage
   LH	E21

   Fig 1: Checking Input Signal

   Courtesy of NISSAN NORTH AMERICA, INC.

   OK or NG 

   OK: GO TO  4.

   NG: GO TO 3.

1. Turn ignition switch OFF.
2. Disconnect IPDM E/R connector.
3. Check continuity between IPDM E/R harness connector (A) and front combination lamp harness connector (B).

   A		B			Continuity
   Connector	Terminal	Connector		Terminal
   E45	29	RH	E20	1	Yes
   	28	LH	E21

   Fig 2: Checking Parking Lamp Circuit

   Courtesy of NISSAN NORTH AMERICA, INC.

   OK or NG 

   OK: Replace IPDM E/R. Refer to , "REMOVAL AND INSTALLATION OF IPDM E/R ".

   NG: Repair harness or connector.

Check continuity between front combination lamp harness connector and ground.

Fig 3: Checking Parking Lamp Ground Circuit

Courtesy of NISSAN NORTH AMERICA, INC.

OK or NG 

OK: Check bulbs.

NG: Repair harness or connector.