Battery Removal and Installation: Installation
WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
- Install the battery (A), then install the battery hold down plate (B).
- Tighten the two nuts (C) equally until the battery is stable.NOTE: Do not deform the battery hold down plate by over-tightening the nuts.
- Do the battery terminal reconnection procedure NOTE: Make sure the battery is installed correctly, and the positive and negative terminals are not reverse connected.