LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Front And Rear Suspension - Inspection And Adjustment) >> Wheel Bolt Replacement >> Front

Wheel Bolt Replacement: Front

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the front hub (see KNUCKLE/HUB/WHEEL BEARING REPLACEMENT ).
  3. Separate the wheel bolt (A) from the hub (B) using a hydraulic press. Support the hub with hydraulic press attachments (C) or equivalent tools.
    Fig 1: Identifying Wheel Bolt
    G05959058Courtesy of AMERICAN HONDA MOTOR CO., INC.
    NOTE:
    • Before installing the new wheel bolt, clean the mating surfaces on the bolt and the hub.
    • The graphic shows a front hub.
  4. Insert the new wheel bolt into the hub while aligning the splined surfaces on the hub hole with the wheel bolt.
    NOTE:
    • Before installing the new wheel bolt, clean the mating surfaces on the bolt and the hub.
    • Degrease the area around the wheel bolt.
    • Make sure the wheel bolt is installed vertically in relation to the hub disc surface.
  5. Install the wheel bolt using a hydraulic press until the wheel bolt shoulder is fully seated.
  6. Install the front hub (see KNUCKLE/HUB/WHEEL BEARING REPLACEMENT ).
    NOTE: If you cannot tighten the wheel nut to the specified torque value when installing the wheel, replace the front hub or rear hub bearing unit as an assembly.
scientia non olet · About LEMON Manuals