LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Fuel Supply System) >> Fuel Pressure Regulator Replacement

Fuel Pressure Regulator Replacement

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fuel tank unit (see FUEL TANK UNIT REMOVAL AND INSTALLATION  ).
  2. Remove the reservoir (A).
    Fig 1: Identifying Fuel Pressure Regulator And Reservoir
    G08052582Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the bracket (A).
    Fig 2: Identifying Fuel Pressure Regulator, Bracket And Clip
    G08052583Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the clip (B).
  5. Remove the fuel pressure regulator (C).
  6. Install the parts in the reverse order of removal with new O-rings (D). When installing the fuel tank unit, align the makes on the unit and the fuel tank (see INSTALLATION  ).
    NOTE:
    • Coat the O-rings with clean engine oil; do not use any other oils or fluids.
    • Do not pinch the O-rings during installation.
    • Use all the new parts supplied in the pressure regulator replacement kit.
scientia non olet · About LEMON Manuals