Selector Control Shaft Bearing Replacement: Overview

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

Bearing Remover Shaft Set, 15 mm 07936-KC10500
Slide Hammer 07936-371020A
Driver Handle, 15 x 135L 07749-0010000
Bearing Driver Attachment, 32 x 35 mm 07746-0010100

Remove the selector control shaft bearing from the torque converter housing using the slide hammer and the 15 mm bearing remover shaft set.

Fig 1: Removing Selector Control Shaft Bearing From Torque Converter Housing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install a new bearing until it bottoms out in the torque converter housing using the 15 x 135L driver handle and the 32 x 35 mm bearing driver attachment.

Fig 2: Installing Bearing Until It Bottoms Out In Torque Converter Housing
Courtesy of AMERICAN HONDA MOTOR CO., INC.