Reverse Idler Gear Removal/Installation

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

Remove the reverse idler gear assembly (A) from the transmission housing.

Fig 1: Reverse Idler Gear Tightening Sequence With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the reverse idler gear assembly in the transmission housing. Tighten the bolts in the numbered sequence shown.