How to End a Troubleshooting Session (required after any troubleshooting)

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Reset the PCM/TCM with the HDS while the engine is stopped.

Turn the ignition switch to LOCK (0).
Turn the ignition switch to ON (II), and wait for 30 seconds.
Turn the ignition switch to LOCK (0), and disconnect the HDS from the DLC.
Start the engine with the shift lever in P or N, and warm it up to normal operating temperature (the radiator fan comes on).
To verify that the problem is repaired, test-drive the vehicle for several minutes at speeds over 31 mph (50 km/h) or under the same conditions as those indicated by the freeze data.