LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Automatic Transmission) >> Drive Plate Removal and Installation

Drive Plate Removal and Installation

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission assembly (see TRANSMISSION REMOVAL  ).
  2. Remove the drive plate (A) and the washer (B) from the engine.
    Fig 1: Locating Drive Plate And Washer With Torque Specifications
    G08057446Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install the drive plate and the washer on the engine crankshaft, and tighten the eight bolts in a crisscross pattern in at least two steps.
  4. Install the transmission assembly (see TRANSMISSION INSTALLATION  ).
scientia non olet · About LEMON Manuals