Special Tools Required

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

Clutch Compressor Attachment 07ZAE-PRP0100

Set a dial indicator (A) on the clutch end-plate (B).

Fig 1: Setting Dial Indicator On Clutch End-Plate
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Zero the dial indicator with the clutch end-plate lifted up to the snap ring (C).
Release the clutch end-plate to lower it, then put the clutch compressor attachment on the end-plate (A).

Fig 2: Measuring Clearance Between Clutch End-Plate And Top Disc
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Press the clutch compressor attachment down with 150-160 N (15-16 kgf, 33-35 lbf) (B) using a force gauge, and read the dial indicator (C).
The dial indicator reads the clearance (D) between the clutch end-plate and the top disc (E). Take measurements in at least three places, and use the average as the actual clearance.
Clearance Between Clutch End-Plate and Top Disc

Standard:

1st Clutch: 1.50-1.70 mm (0.0591-0.0669 in)

2nd Clutch: 1.25-1.45 mm (0.0492-0.0571 in)

3rd Clutch: 1.25-1.45 mm (0.0492-0.0571 in)

4th Clutch: 1.50-1.70 mm (0.0591-0.0669 in)

5th Clutch: 1.25-1.45 mm (0.0492-0.0571 in)

6th Clutch: 1.25-1.45 mm (0.0492-0.0571 in)
If the measurement is out of the standard, replace the clutch assembly.