Front Toe Inspection/Adjustment

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

Use commercially available computerized four wheel alignment equipment to measure wheel alignment (caster, camber, toe, and turning angle). Follow the equipment manufacturer's instructions.

Set the steering column to the middle tilt position and telescopic positions. Center the steering wheel spokes, and install a steering wheel holder tool.
Check the toe with the wheels pointed straight ahead.
Front toe-in: 0±2 mm (0±0.08 in)
- If adjustment is required, go to step 3.
- If no adjustment is required, remove the alignment equipment.
Loosen the tie-rod locknuts (A) while holding the flat surface sections (B) of the tie-rod end with a wrench, and turn both tie-rods (C) until the front toe is within specifications.

Fig 1: Turning Tie-Rods With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
After adjusting, tighten the tie-rod end locknuts to the specified torque. Reposition the rack-end boot if it is twisted or displaced.