Camber Inspection

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

Use commercially available computerized four wheel alignment equipment to measure wheel alignment (caster, camber, toe, and turning angle). Follow the equipment manufacturer's instructions.

Check the camber angle.

Camber angle:

Front: -0°30'±1°

Rear: -0°30'±45'

If the measurement is within specification, measure the toe-in.
If the measurement for the front camber is not within the specification, go to front camber adjustment.
If the measurement for the rear camber is not within the specification, check for bent or damaged suspension components.