LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Automatic Transmission) >> Shafts and Clutches >> Countershaft Reverse Selector Hub Removal

Countershaft Reverse Selector Hub Removal

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the reverse selector hub from the countershaft by hand. If the reverse selector hub (A) cannot be removed by hand, it is press-fitted to the countershaft (B), and must be removed from the countershaft with a press. Place 4th-5th gear (C) on press bases (D), and place a shaft protector (E) between the countershaft and press to prevent damaging the countershaft.
    NOTE: Some reverse selector hubs are not press-fitted, and can be removed without using a press.
    Fig 1: Removing Reverse Selector Hub
    G06768660Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Press the countershaft out of the press-fitted reverse selector hub, and remove the countershaft while holding the underside the countershaft. Do not let the countershaft fall down when pressing the countershaft out of the press-fitted reverse selector hub.
  3. Remove the remaining parts from the countershaft, if necessary.
scientia non olet · About LEMON Manuals