Paddle Shifter - (Downshift Switch) Replacement

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.

SRS components are located in this area. Review the SRS COMPONENT LOCATION INDEX and PRECAUTIONS AND PROCEDURES before doing repairs or service.

Remove the steering wheel (see STEERING WHEEL REMOVAL ).
Remove the four screws (A) securing the steering wheel rear cover (B), then remove the steering wheel rear cover.

Fig 1: Identifying Screws Securing Steering Wheel Rear Cover
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the paddle shifter - (downshift switch) connector (A) from its holder, and disconnect the connector.

Fig 2: Removing Paddle Shifter - (Downshift Switch) Connector From Holder
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the screws (B) securing the paddle shifter - (C), and remove the paddle shifter -.
Install a new paddle shifter - on the steering wheel, and secure it with the screws.
Connect the paddle shifter - connector securely, and install the connector in the connector holder.
Install the steering wheel rear cover.
Install the steering wheel (see STEERING WHEEL REMOVAL ).