Keyless Operation Does Not Work (LOCK, UNLOCK, PANIC)
WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- If the LOCK and UNLOCK buttons work OK, but the PANIC button does not, see the troubleshooting for THE HORN DOES NOT SOUND AND/OR THE HEADLIGHTS DO NOT FLASH WHEN THE PANIC BUTTON ON THE TRANSMITTER IS PRESSED .
- Before troubleshooting, check the B-CAN DTCs. If any DTC is indicated, refer to the B-CAN System Diagnosis Test Mode A, and troubleshoot the indicated DTCs first. (See TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A ).
- Turn the ignition switch to ON (II).
- Try to start the engine.
Does the engine start?
YES - Go to step 3.
NO - Go to the immobilizer symptom troubleshooting (see SYMPTOM TROUBLESHOOTING ).
- Turn the ignition switch to LOCK (0).
- Try to start the engine.
Does the engine start?
YES- The immobilizer system is OK, Go to step 5.
NO- Go to the immobilizer symptom troubleshooting. (see SYMPTOM TROUBLESHOOTING )
- Turn the ignition switch to LOCK (0).
- Do TRANSMITTER TEST
.
Is the transmitter OK?
YES - Replace the immobilizer-keyless control unit (see IMMOBILIZER-KEYLESS CONTROL UNIT REPLACEMENT ).
NO - Replace the transmitter.