LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Engine Lubrication) >> Oil Filter Feed Pipe Replacement

Oil Filter Feed Pipe Replacement

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the filter (see ENGINE OIL FILTER REPLACEMENT  ).
  2. Remove the oil filter feed pipe.
    Fig 1: Identifying Oil Filter Feed Pipe
    G05952669Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install two 20 x 1.5 mm nuts (A) onto the new oil filter feed pipe. Hold one nut with a wrench, then use a second wrench to tighten the other nut.
    Fig 2: Identifying Nuts
    G05952670Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Apply new engine oil to the oil filter feed pipe threads, then torque the oil filter feed pipe to 39 N.m (4.0 kgf.m, 29 lbf.ft), then remove the nuts from the oil filter feed pipe.
  5. Install the oil filter (see ENGINE OIL FILTER REPLACEMENT  ).
scientia non olet · About LEMON Manuals