DTC P0630: VIN Not Programmed or Mismatch

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Before you troubleshoot, record all freeze data and any on-board snapshot, and review GENERAL TROUBLESHOOTING INFORMATION .
This DTC is stored only when the ECM/PCM does not have the VIN information of the vehicle. Use the HDS to input the missing VIN information.

Turn the ignition switch to ON (II).
Check the VIN with the HDS.
Does the HDS show the vehicle's VIN?

YES: Go to step 5.

NO: Go to step 3.
Input the VIN to the ECM/PCM with the HDS.
Does the screen show COMPLETE?

YES: Go to step 5.

NO: Go to step 4.
Check for Confirmed DTCs with the HDS.
Is DTC P062F indicated?

YES: Go to the DTC P062F troubleshooting (see DTC P062F: ECM/PCM INTERNAL CONTROL MODULE KEEP ALIVE MEMORY (KAM) ERROR ).

NO: Go to step 9.
Clear the DTC with the HDS.
Turn the ignition switch to LOCK (0).
Turn the ignition switch to ON (II), and wait 5 seconds.
Check for Pending or Confirmed DTCs with the HDS.
Is DTC P0630 indicated?

YES: Go to step 9.

NO: Intermittent failure, the system is OK at this time.
Update the ECM/PCM if it does not have the latest software (see ECM/PCM UPDATE ), or substitute a known-good ECM/PCM (see SUBSTITUTING THE ECM/PCM ).
Check for Pending or Confirmed DTCs with the HDS.
Is DTC P0630 indicated?

YES: If the ECM/PCM was updated, substitute a known-good ECM/PCM (see SUBSTITUTING THE ECM/PCM ), then recheck. If the ECM/PCM was substituted, go to step 1.

NO: If the ECM/PCM was updated, troubleshooting is complete. If the ECM/PCM was substituted, replace the original ECM/PCM (see ECM/PCM REPLACEMENT ). If any other Pending or Confirmed DTCs are indicated, go to the indicated DTC's troubleshooting.