Special Tools Required
WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
- TPMS sensor initializer tool AKS0620006
- TPMS trigger tool ATEQ VT55
Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
- Make sure the TPMS tool has the latest software. Check the official Honda service website for more service information about the TPMS tool.
- TPMS tool is necessary to do this procedure.
- Let the vehicle sit for at least 5 minutes to allow the sensors to switch to sleep mode.
- This procedure locates where the tire pressure sensors 1, 2, 3, 4 are mounted, when activated by the TPMS tool.
- Position the vehicle at least 10 ft (3 m) away from other vehicles that have tire pressure sensors.
- With the ignition switch in LOCK (0), connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
- Turn the ignition switch to ON (II).
- Make sure the HDS communicates with the vehicle and the TPMS control unit. If it doesn't, troubleshoot the DLC circuit (see DLC CIRCUIT TROUBLESHOOTING ).
- Using the HDS, bring up the TOMS data list, scroll down to the bottom, and locate the four tire sensors ID numbers. These are the ID numbers assigned to each tire location.
- Follow the HDS screen prompts under tire pressure sensor ID learn, to turn on the TPMS tool.
- Activate the TPMS sensor using the ATEQ VT55 tool.
- The ATEQ VT55 will display the sensor data including the ID number.
- Locate the tire pressure sensor ID number in the TPMS DATA LIST with the HDS, and match it to the sensor ID on the TPMS tool. Note the sensor location.
- Turn the ignition switch to LOCK (0).