LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Tire Pressure Monitoring System) >> General Troubleshooting Information >> How to Troubleshoot DTCs

How to Troubleshoot DTCs

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.

DTC troubleshooting procedures assume the cause of the problem is still present and the TPMS indicator is still on. Do not use a troubleshooting procedure unless the system has set the DTC listed for it.

NOTE: For DTCs 11, 13, 15 and 17 (tire low tire pressure), the TPMS indicator comes on only if the DTCs are caused by a system problem rather than low tire pressure.
  1. Ask the customer to describe 1 he conditions when the indicator came on, and try to reproduce the same conditions for troubleshooting. Find out if the customer checked and/or adjusted tire pressures since the indicator came on.
  2. If an indicator does not come on during the test-drive, check for loose terminals, poor contact due to damaged terminals, etc. before you start troubleshooting.
  3. After troubleshooting, repair and clear the DTCs, and test-drive the vehicle. Make sure no indicators come on.
scientia non olet · About LEMON Manuals