DTC 81-3D, 81-3E, 81-59: Central Processing Unit (CPU) Internal Circuit Malfunction

WARNING: This page is about a different car, the 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. (See General Troubleshooting Information ).

Turn the ignition switch to ON (II).
Clear the DTC with the HDS.
Start the engine.
Turn the steering wheel from lock-to-lock several times.
Check for DTCs with the HDS.
Is DTC 81-3D, 81-3E, or 81-59 indicated?

YES - Go to step 6.

NO - Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting (see Intermittent Failures ).
Update the VSA modulator-control unit if it does not have the latest software (see VSA MODULATOR-CONTROL UNIT UPDATE ).
Start the engine.
Turn the steering wheel from lock-to-lock several times.
Check for DTCs with the HDS.
Is DTC 81-3D, 81-3E, or 81-59 indicated?

YES - Check for loose terminals in the VSA modulator-control unit 36P connector. If the symptom/indication is still present, replace the VSA modulator-control unit (see VSA MODULATOR-CONTROL UNIT REMOVAL AND INSTALLATION ).

NO - If the VSA modulator-control unit was updated, troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.