DTC 27-24: Steering Angle Sensor Exchange Malfunction

WARNING: This page is about a different car, the 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. (See General Troubleshooting Information ).

Turn the ignition switch to ON (II).
Turn the steering wheel one turn. Check the STEERING ANGLE in the VSA DATA LIST with the HDS.
Is there about 288 degrees to 432 degrees (-288 degrees to -432 degrees)?

YES - Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting (see Intermittent Failures ).

NO - Replace the steering angle sensor (see STEERING ANGLE SENSOR REPLACEMENT ).