DTC 25-19, 25-21, 25-23: Yaw Rate-Lateral Acceleration Sensor Startup Time Malfunction; Yaw Rate Sensor Neutral Position Malfunction; Yaw Rate Sensor Circuit Intermittent Interruption
WARNING: This page is about a different car, the 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. (See General Troubleshooting Information ).
- Turn the ignition switch to ON (II).
- Clear the DTC with the HDS.
- Do the VSA sensor neutral position memorization (see VSA Sensor Neutral Position Memorization ).
- Turn the ignition switch to LOCK (0), then turn it to ON (II) again.
- Wait 60 seconds or more.
- Check for DTCs with the HDS.
Is DTC 25-19,25-21, or 25-23 indicated?
YES - Replace the yaw rate-lateral acceleration sensor (see YAW RATE-LATERAL ACCELERATION SENSOR REPLACEMENT ).
NO - Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting (see Intermittent Failures ).