DTC 51-11, 51-13: Motor Lock; Motor Drive Circuit Malfunction
WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. (See General Troubleshooting Information ).
- Turn the ignition switch to ON (II).
- Clear the DTC with the HDS.
- Turn the ignition switch to LOCK (0), then turn it to ON (II) again.
- Wait 5 seconds.
- Operate any one of the four solenoids, as listed, in the ABS FUNCTION TEST five times with the HDS.ABS FUNCTION TEST REFERENCE TABLE
-LFT FT SOLENOID -RT FT SOLENOID -LFT REAR SOLENOID -RT REAR SOLENOID - Check for DTCs with the HDS.
Is DTC 51-11 or 51-13 indicated?
YES - Replace the ABS modulator-control unit (see ABS MODULATOR-CONTROL UNIT REMOVAL AND INSTALLATION ).
NO - Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting (see INTERMITTENT FAILURES ).