LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Fuel And Emissions Systems) >> How to Set Readiness Codes >> Evaporative Emission (EVAP) Control System Monitor and Readiness Code >> Procedure

Evaporative Emission (EVAP) Control System Monitor and Readiness Code: Procedure

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the HDS to the DLC.
  2. Start the engine.
  3. Select EVAP TEST in the INSPECTION MENU with the HDS, then select the FUNCTION TEST in the EVAP TEST MENU.
    • If the result is normal, readiness is complete.
    • If the result is not normal, go to the next step.
  4. Check for a Pending DTC. If there is no DTC, one or more of the enable criteria were probably not met; repeat the procedure.
scientia non olet · About LEMON Manuals