LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> Side Impact Sensor (Second) Replacement >> Removal

Side Impact Sensor (Second) Replacement: Removal

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
  1. Do the battery terminal disconnection procedure (see BATTERY TERMINAL DISCONNECTION AND RECONNECTION ), then wait at least 3 minutes before starting work.
  2. Remove the cargo area side trim (see TRIM REMOVAL/INSTALLATION - REAR SIDE AREA ).
  3. Disconnect the side impact sensor (second) 2P connector (A) on the floor wire harness.
    Fig 1: Identifying Floor Wire Harness 2P Connector & Side Impact Sensor
    G05960625Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the TORX bolt (B) using a TORX T30 bit, then remove the side impact sensor (first) (C).
scientia non olet · About LEMON Manuals