LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> Precautions and Procedures >> Spring-Loaded Lock Connector >> Side Airbag and Side Curtain Airbag Connectors >> Disconnecting

Side Airbag and Side Curtain Airbag Connectors: Disconnecting

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.

To release the lock, pull the spring-loaded sleeve (A) toward the stop (B) while holding the opposite half of the connector. Then pull the connector halves apart. Be sure to pull on the sleeve and not on the connector half.

Fig 1: Identifying Spring-Loaded Sleeve & Stop
G05960414Courtesy of AMERICAN HONDA MOTOR CO., INC.