Special Tools Required

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.

Back Probe Adapter, 17 mm 07TAZ-001020A

Make sure the battery is fully charged when doing electrical tests. If the battery is not fully charged, the results of the tests may not be accurate.
When using electrical test equipment, insert the probe of the tester into the wire side of the connector (except waterproof connectors). Do not insert the probe of the tester into the terminal side of the connector, and do not tamper with the connector.

Fig 1: Identifying Precautions For Inserting Probe Of Tester Into Wire Side Of Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Use back probe adapter 07TAZ-001020A. Do not insert the probe forcibly.

Fig 2: Identifying Probe Adapter 07TAZ-001020A
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Use specified service connectors in troubleshooting. Using improper tools could cause a diagnostic error due to poor metal-to-metal contact.